the coupler ends about 8 feet apart. Make certain the
feet away from the water heater. Install the barrel plug
ends, are located at the spot where the showers are to
(2) into the large opening in the fuel drum. Connect one
be taken and downstream from the water pump.
fuel hose assembly (1) to the fitting on the barrel plug
marked SUPPLY, and connect the other end of the hose
(10) Insert the three shower stand legs into the
assembly to the fuel filter on the water heater. Connect
sleeves of each shower stand riser.
Place the
the other fuel hose assembly (4) to the fitting on the
assembled shower stands beside each hose coupler.
barrel plug marked RETURN, and connect the other end
Make certain the coupler gaskets are present and then
to the fitting on the bottom of the fuel pump.
connect the hose assemblies to the shower stand
(8) Connect the exhaust duct (6) to the vent
adapters as shown in figure 2-10. Make certain the
opening on the water heater. Turn the duct to the right
locking levers are secure.
to lock it in position.
(11) Place the generator set about 15 to 20
NOTE
feet from the water pump and from the water heater (fig.
Do not allow the duct to come in
contact with the hoses or any
(12) Make certain the blower and fuel pump
canvas shelter. Make certain the
motor switch and the water pump motor switch are
exhaust gases are expelled away
turned off before connecting the two power cord cables.
from the shower area.
Connect the two cables to the generator receptacle box
(9) Take the remaining two canvas water
connectors. Connect one cable (1, fig. 2-7) to the water
hose assemblies, and connect them to the couplers,
pump receptacle connector and the other cable to the
located on the water heater upper manifold as shown in
water heater receptacle connector.
and the coupler locking levers are secure. Uncoil the
hose assemblies their entire length (25 feet), and spread
