TM 10-4510-207-14
2.6.3.
Shower Facility Assembly.
NOTE
To install drain hose assembly, reach through access holes in base to
Connect hose ends or raise the shower bases. Use either method you
Find more convenient.
a.
Install six drain hose assemblies (1) (2 inch diameter X5 feet long). Be sure that two hoses extend out of
shower facility toward pump assembly.
b.
Install two caps (2) in end of shower bases (3) away from pump assembly.
CAUTION
Loose caps can get wedged under shower basing damage to the base.
c.
If shower bases (3) were raised for hose connection, carefully lower them together. Push bases together
into final position. Be sure loose caps (4) are not wedged under base.
d.
Install three floor panels (5) and secure to shower bases (3) using attached hook and pile fastener strips.
NOTE
The following procedures are typical for each shower base.
e.
Install five vertical supports (6) into Shower base (3). Note that outer center vertical support is not
installed at this time.
f.
Place shower cover (7) over top frame assembly (8) and carefully guide three outer legs through openings
in back of cover. Secure shower cover to top frame assembly using attached hook and pile fastener strips
(9).
g.
From the inside, lift top frame assembly (8), with shower over (7) attached, and install onto vertical
supports (6). Note that the two outer supports are on the outside of cover.
h.
Install outer center vertical support (10).
i.
Secure shower cover (7) to vertical supports (6 and 10) using attached hook and pile fastener strips (11).
j.
Secure shower cover (7) to inside shower base (3) using attached hook and pile fastener strips.
k.
Repeat above steps to assemble remaining shower stalls.
l.
Secure fastening top frame assemblies (7) to each other using attached hook and pile fastener strips (12).
m. Secure facing shower covers (7) to each other using attached hook and pile fastener strips.
n.
Secure two door panels (13) to outside of assembled shower facility using attached hook and pile fastener
strips.
2-10