TM 10-4510-207-14
This task covers: a. Disassembly b. Assembly
INITIAL SETUP
Tools:
Equipment Conditions:
General Mechanics Tool Set (Appendix B, Section III,
Storage container empty.
Item 1)
NOTE
Repair is limited to replacement of missing or damaged components.
Disassemble only to the extent necessary to repair the item.
If the storage container must be replaced, notify direct support
maintenance.
The following procedures can apply to multiple items. The quantities
listed in the procedures are for only one item.
Refer to figure 4 -16.
a.
Disassembly.
(1) Remove eight screws (1) and hinge (2).
(2) Remove six screws (3) and latch (4).
(3) Raise and support lid (5) then remove five screws (6), tee nuts (7), and bail handle (8).
(4) Raise and support lid (5) then remove 10 screws (9), tee nut (10), and folding handle (11).
(5) Replace any defective, missing, or damaged components.
(6) If storage container was in use, place any removed items back in it.
b.
Assembly.
(1) Be sure any missing or damaged components have been replaced.
(2) Raise and support lid (5) then position folding handle (11) in place and align mounting holes. Secure handle
using five screws (9) and tee nuts (10).
(3) Raise and support lid (5) then position bail handle (8) in place and align mounting holes. Secure handle
using five screws (6) and tee nuts (7).
(4) Position latch (4) n place and align mounting holes then secure using six screws (3).
(5) Position hinge (2) in place and align mounting holes then secure using eight screws (1).
(6) If storage container was in use, place any removed items back in it.
4-41
