TM 10-4510-209-13&P
0021 00
14. Resume driving the rod into the ground with the slide hammer (7) until only one foot of the ground rod
assembly remains above ground. Remove the driving rod (6) and slide hammer from the coupling
(10).
NOTE
An electrical connector is fitted to the free end of the grounding cable. The connector is
not used in this installation. Do not remove the connector the connector is necessary
for use in other installations.
15. Attach grounding cable (5) to the electrical clamp (12). Tighten the electrical clamp.
16. Remove nut(s) (13), washer(s) (14) from stud (4) on panel (2).
17. Remove splice connector nut (15) from splice connector (3).
18. Place splice connector (3) over grounding stud (4).
19. Install washers (14) and nut (13) onto stud (4). Do not tighten at this time.
20. Slip grounding cable (5) through the splice connector (3).
21. Install and tighten splice connector nut (15) until grounding cable (5) is securely fastened to
grounding stud (4) using adjustable wrench provided.
22. Tighten washer(s) (14) and nut(s) (13) securely.
23. Reconnect 60A pigtail cable (1) to power entry panel (2).
24. Reconnect main power supply, and operate CL/CLS IAW operating procedures given in WP 0006 00
(CL) or 0009 00 (CLS).
0021 00-6
