TM 10-8400-201-23
Table 23-2. Drawers Finished Measurements
1/2 WAIST 1/
INSEAM 2/
1/2 LEG BOTTOM WIDTH 3/
SIZE
IN (CM)
IN (CM)
IN (CM)
26
11 1/2
(29.21)
27
(68.58)
5
(12.70)
28
12
(30.48)
27 1/2
(69.85)
5 1/8
(13.00)
30
12 1/2
(31.75)
28
(71.12)
5 1/4
(13.33)
32
13
(33.02)
28 1/2
(72.39)
5 3/8
(13.63)
34
13 1/2
(34.29)
29
(73.66)
5 1/2
(13.97)
36
14
(35.56)
29 1/2
(74.93)
5 5/8
(14.27)
38
14 1/2
(36.83)
30
(76.20)
5 3/4
(14.60)
40
15
(38.10)
30 1/2
(77.47)
5 7/8
(14.90)
42
15 1/2
(39.37)
31
(78.74)
6
(15.24)
Tolerance
1/2
1/2
1/4
1/
Measure along center of waistband from folded edge to folded edge.
2/
Measure inseam of drawers from crotch seam to bottom edge of drawers.
3/
Measure width of leg at hem from folded edge to folded edge of cuff.
NOTE
All measurements shall be taken with the drawers laid flat and under no tension.
23-8. CLEANING.
a.
General. The Chemical Protective Underwear (CPU) may be laundered an unlimited number of times
during training life. Dirty clothes wear out quickly because dirt cuts textile fibers and retains moisture from
perspiration. Prior to laundering and drying, make sure all slide fasteners are engaged and all fastener
tapes are fastened. Securing these items will result in a better laundered garment.
b.
Stain/Spot Removal. (For training only)
NOTE
Do not bleach or dry clean CPU.
(1)
Following instructions on container, use a pre-wash or spot remover directly on the stain or spot
followed by a standard laundry cycle with type II detergent.
Change 4 23-7
