TM 55-1615-226-40
as required to obtain 0.000 inch to 0.002 inch gap (see
view C). This measurement should be taken between
the shim (22) and housing assembly (23). Install
washer (3) and nut (2). Tighten nut to a torque of
200-400 inch- pounds. Install cotter pin (l). Asign-off
I
inspection is required to insure the installation of
cotter pin.
NOTE
There should be NO end
play at inner race. A total
end play of 0.038 inch to
0.082 inch is required be-
tween drive link and scis-
sors. This end play should
be equally divided on both
sides.
i. Install opposite scissors assembly and drive
link in the same manner.
j. Ensure lubrication of all points provided with
lubrication fittings. Lubricate with grease (item 7,
table 2-l).
2-38. Painting Requirements.
Identi& lube ~ittinga by paimting a l/8 inch wide
band, l/2 inch to 1 inch O.D. around fitting with
Acrylic Lacquer per Fed Std 595, Color No. 17038
(Gloss Black). As an alternate method, the band may
be made from pressure sensitive tape, 3M Scotcha.1,
No. 3655 (Black) or equivalent.
2-39. Final Reassembly. (Not Applicable)
*US. GOVERNMENT PRINTING OFFICE: 1992- 654-028/604!0
Change 4 2-15 (2-16 blank)
