TM 9-1005-237-23&P2-9.A. M6 BAYONET-KNIFE AND M7 BAYONET-KNIFE--MAINTENANCE INSTRLUCTIONS (Cont).INSPECTION/REPAIR (Cont)NOTELength of the M6 and M7 blade measured from guard must not beless than 6-1/8 in. (15.56 cm) after repointing.5. Inspect/check guard area (6) of blade assembly andassembly for looseness. If loose, evacuate bayonet tomaintenance.6. Inspect for worn or shiny areas on blade assembly,follows step 11.7. If point is broken,evacuate to D. S. Maintenance.plate area (7) of bladedirect supportre-establish finish as8. For M6 bayonet only,inspect lock-release lever (1) for bends and wear. Lock-release lever may be repaired by straightening.9. Inspect compression helical spring (2) for kinks, set, and breaks. If anyof these situations are found, replace.2-14
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
