TM 9-1005-237-23&P
2-8. PREVENTIVE MAINTENANCE CHECKS AND SERVICES. (cont)
.
Table 2-2. ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES
QUARTERLY SCHEDULE (Cont)
Item
Item To Be
Not Fully Mission
No.
Inspected
Procedures
Capable If:
—
24
M9 Scabbard
Inspect for cracked or broken
D -
Scabbard body
(Cont)
scabbard body. Cracks less than 1/2
has cracks over
inch in length are not cause for
1/2 inch long or
repair. Missing pieces less than
has missing pieces
1/8 inch in diameter are not cause
over 1/8 inch in
for repair.
diameter
25
Inspect for bent or broken belt
D - Belt fastener
fastener.
will not securely
fasten the scab-
bard to the belt
26
Inspect for cracked or broken
D - Cutter plate/
screw driver tip or wire cutter
stud will not cut
plate/stud.
wire
SH - Screw driver
is unable to re-
move bayonet cap
screw
27
Inspect dot snap to ensure it
D - Dot snap
functions
doesn’t function
Section IV. MAINTENANCE INSTRUCTIONS
2-9.A. M6 BAYONET-KNIFE AND M7 BAYONET-KNIFE - MAINTENANCE INSTRUCTIONS.
—
THIS TASK COVERS:
a. Disassembly
c. Clean/Lubricate
b. Inspection/repair
d. Reassembly
.
INITIAL SETUP
Tools and Special Tools
References
Small arms repairman tool kit (app B)
Appendix B
Appendix C
Materials/Parts
Appendix D
Abrasive cloth (item 4, app D)
CLP (item 3, app D)
NOTE
Dry cleaning solvent (item 5, app D)
The following procedures apply
LAW (item 9, app D)
to both tile M8 and M7 Bayonet-
LSA (item 10, app D)
knives, except as noted.
Rubber gloves (item 7, app D)
Solid film lubricant (item 8, app D)
Wash pan (item 11, app D)
Wiping rag (item 12, app D)
2-11
