CHAPTER 2 ORGANIZATIONAL
Section I. REPAIR PARTS,
TM 9-1005-237-23&P
MAINTENANCE INSTRUCTIONS
SPECIAL TOOLS; TEST, MEASUREMENT AND DIAGNOSTIC
EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT
2-1. COMMON TOOLS AND EQUIPMENT. For authorized common tools and equipment refer
to the Modified Table of Organization and Equipment (MTOE) applicable to your
unit.
2-2. SPECIAL TOOLS, TMDE AND SUPPORT EQUIPMENT. There are no special tools, TMDE
or support equipment.
2-3. REPAIR PARTS. Repair parts are listed and illustrated in appendix C of
this manual.
Section II. SERVICE UPON RECEIPT
2-4. GENERAL. This section contains instructions for services to be performed
by the using organization upon the receipt of a new M6 Bayonet-knife with
scabbard, M? Bayonet-knife with scabbard or M9 Multipurpose Bayonet System.
NOTE
a.Where the word “lubricant” is cited in this TM, interpret to mean Cleaner
Lubricant and Preservative (CLP) (app D, item 3), Lubricating Oil, Weapons Semi-
fluid (LSA) (app D, item 10), or Lubricating Oil Weapons (LAW) (app D, item 9)
can be utilized as applicable. The following constraints must be adhered to:
b. Under all but the coldest arctic conditions, LSA or CLP are the
lubricants to use on the bayonet/scabbard. Either can be used at -100F and
above. However, do not use both on the same bayonet/scabbard at the same time.
c. LAW is the lubricant to use during cold arctic conditions, +lO°F and
below.
d. Any of the lubricants can be used from -lOOF to +1O0F.
e. Do not mix lubricants on the same bayonet/scabbard. The bayonet/scabbard
must be thoroughly cleaned during change from one lubricant to another. Dry
Cleaning Solvent (SD) (app D, item 5) is recommended for cleaning the bayonet
during change from one lubricant to another. Do not use SD on the scabbard or
the handle.
2-1
