TM 10-3510-206-12
CHAPTER 4
ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
Section 1. SERVICE UPON RECEIPT OF MATERIEL
4-1. Inspecting and Servicing the Equipment
or broken mercury bulbs utilized with the
dryer tumbler air temperature control, it is
a. Deprservation. Prepare the unit for in-
essential that the following protective
spection and operation as outlined on DA Form
measures be taken.
2258, attached on or near the operator's controls.
(1) Remove the dial face cover from
b. Inspection. Make a thorough visual in-
the control. Insert cushioning material,
spection of the entire laundry unit for loose or
such as soft sponge rubber or packing
missing mounting hardware, damage, and missing
paper into the mercury bulb housing of the
parts and components. Correct all faults or report
control. Reinstall the dial face cover.
the conditions to directt support maintenance.
(2) Upon completion of the towing
c. Servicing.
operation, remove the cushioning material
( 1 ) Engine-Generator. Refer to TM
from the mercury bulb housing and
5-6115-275-14 and servicece the engine-generator.
reinstall the cover.
(2) Trailer. Refer to TM 9-2330-274-14 and
a. Tow the trailer to the water source and set it
service the trailer.
up with the water heater side next to the water
(3) Laundry unit.
source. Set the handbrake levers and lower the
(a) Perform the daily preventive main-
trailer support and caster wheel. If necessary, dig
tenance services.
holes or block wheels to make sure the trailer is
(b) Lubricate the unit in accordance with
level.
the current Lubrication order.
4-2. Installation
the fuel container to the fuel filter (3) and to the
CAUTION
fuel pump (4) of the water heater (5).
Prior to all towing operations of the
laundry unit, in order to prevent damaged
4-1
