TM 10-3510-206-12
4-69. Washer-Extractor Electric Timer
4-68. Warning Bell
a. Removal. Refer to figure 4-90 or 4-91 and
a. Removal. Refer to figure 4-92 and the
the following instructions to remove the tumbler _
following instructions to remove the warning bell.
electric timer.
(1) Tag and disconnect leads from the alarm
(1) Tag and disconnect all necessary leads
bell.
(2) Remove the screws and washers securing
from the washer-extractor timer.
(2) Remove the screws and washers which
the alarm bell to the control box.
secure the timer to the control panel.
(3) Remove the alarm bell.
(3) Remove the timer.
b. Installation.
b. Installation.
(1) Position the alarm bell in place on the
(1) Position the washer-extractor timer in
control box.
place on the control panel.
(2) Secure with washers and screws.
(2) Secure with washers and screws.
(3) Reconnect leads to the alarm bell.
(3) Reconnect all leads.
Figure 4-92. Warning bell, removal and installation.
Section XXIII. AIR LINES, WASHER-EXTRACTOR MSIN DRIVE BRAKE
ASSEMBLY,
MAIN
DRIVE
BELT
ISLER
PULLEY,
AIR
CYLINDER AND MAIN DRIVE SHEAVE, DOOR ASSEMBLY,
AND VALVE DRAIN ASSEMBLY
4-70. Air Lines
Clean parts using dry compressed air and a clean
cloth.
a. Removal. Refer to figure 4-93 and remove
c. Inspection and Repair.
the air lines in the numerical sequence indicated.
(1) Inspect the hoses and hardware for
b. Cleaning.
(2) Replace parts as necessary.
Do not use compressed air for cleaning
d. Installation. Refer to figure 4-93 and install
purposes except where reduced to less than
the air lines in the reverse of numerical sequence
30 psi and then only with effective chip
indicated ,
guarding and personal protective equip-
ment.
4-132
