TM 10-3510-208-12
(1) Removal.
(b) Secure with washers and screws.
(c) Reconnect leads to the extractor starter.
(a) Refer figure 4-90 for Eidal Model and
n. Fuseholder.
the following instructions to remove the magnetic
control soleniods and air valves.
(1) Removal. Refer to figure 4-90 or 4-91 and
l. Tag and disconnect leads from&
the following instructions to remove the
fuseholder.
magnetic control valve.
2. Unscrew the control valve from the air
(b) Tag and disconnect leads from the
valve.
fuseholder.
3. Remove the air line from the air valve.
(c) Remove the screws and washers which
4. Unscrew the air valve from the air
secure the fuseholder to the control panel.
manifold assembly.
(d) Remove the fuseholder.
(b) Refer to figure 4-91 for Edro Model and
(2) Installation.
remove the magnetic control solenoids and air
(a) Place the fuseholder in place on the
valves in the same manner as stated above.
(2) Installation.
control panel.
(b) Secure with washers and screws.
(a) Install the air valve in the air manifold
(c) Reconnect leads to the freeholder.
assembly.
(d) Install fuses in the fuseholder.
(b) Install the air line to the air valve.
o. Transformer.
(c) Install the magnetic control valve to the
(1) Removal. Refer to figure 4-90 and 4-91
air valve,
and the following instructions to remove the
(d) Reconnect leads
r. Washer Motor Forward Contactor.
transformer.
(a) Tag and disconnect leads from the
(1) Removal. Refer to figure 4-90 or 4-91 and
the following instructions to remove the washer
transformer.
(b) Remove the screws and washers that
motor forward contactor.
secure the transformer to the control panel.
(a) Tag and disconnect leads from the
washer motor forward contactor.
(c) Remove the transformer.
(2) Installation.
(b) Remove the screws and washers that
secure the washer motor forward contactor to the
(a) Position the transformer in place on the
control panel.
control panel.
(c) Remove the washer motor forward
(b) Secure transformer with washers and
screws.
contactor.
(2) Installation.
(c) Reconnect leads to the transformer.
(a) Position the washer motor forward
p. Relay.
contactor in place on the control panel.
(1) Removal Refer to figure 4-90 or 4-91 and
remove the relay by pulling straight out to release
(b) Secure the contactor to the control panel
the relay from the socket.
with washers and screws.
(2) Installation. Push relay into the socket
(c) Reconnect leads to the washer motor
forward contactor.
using a straight forward motion.
q. Magnetic Control Solenoid and Air Valves.
4-128
