TM 10-3510-208-34 b. Disassembly.        Refer    to    the    following paragraphs for the removal and disassembly of washer- extractor parts and components. c. Cleaning. WARNING Clean   all   parts   in   a   well-ventilated area.      Avoid   inhalation   of   solvent fumes   and   prolonged   exposure   of skin    to    cleaning    solvent.        Wash exposed skin thoroughly. Dry cleaning solvent (Fed. Spec. P-D-680) used   to   clean   parts   is   potentially dangerous to personnel and property.      Do   not   use   near   open flame or excessive heat.  Flash point of solvent is 100 to 138F. (38 to 59C.). Clean the metal parts with cleaning solvent, Fed. Spec. P-D-680 and dry thoroughly. d. Inspection    and    Repair.        Refer    to    the following paragraphs for inspection and repair instructions covering washer-extractor parts and components. e. Installation. (1) Refer   to   figure   7-2   and   install   the washer-extractor assembly. (2) Refer   to   figure   7-1   and   install   the holddowns. 7-3. Washer-Extractor Door and Front Cover a. Removal and Disassembly. (1) Remove the cotter pins (1 and 4, fig. 7-3), washers (2 and 5) and pins (3 and 6) and remove the door latch link (7). (2) Remove the stud (8) and remove the washer door handle (9). (3) Remove  the  rivets  (101  and  remove the door handle support (11). (4) Remove the stud (12) and remove the door lock catch (13). (5) Remove  the  rivets  (14)  and  remove the door lock support (15). (6) Remove the screws (16) and lockwashers (17) and remove the lock clamping cylinder (18). (7) Disconnect   all   conduit,   remove   the elbow  (19)  and  locknut  (20)  from  the  sensitive  switch (23). (8) Remove the screws (21) and lockwashers  (22)  and  remove  the  sensitive  switch  (23) from the front head sheet (41). (9) Remove  the  cotter  pins  (24)  and  pin (25) and remove the door assembly (261. (10) Remove  the  bushings  (27)  from  the door (28). (11) Remove the screw (29) and lockwasher (30). (12) Remove  the  rivets  (31)  and  remove the hinge bracket (32). (13) Remove the screws (33) and remove the clamp ring (34), gasket (35) and door glass (36). (14) Remove  the  clamp  ring  (37),  gasket (38) and seal (39). (15) Remove the screws (40) and remove the front head sheet (41) and gasket (42). 7-3