EXTRACTOR DRIVE UNIT - TM-10-3510-209-24

EXTRACTOR ASSEMBLY (CONT) - TM-10-3510-209-24_128

TM-10-3510-209-24
Page Navigation
121

TM 10-3510-209-24 2-29. EXTRACTOR DRIVE UNIT This task covers: Service INITIAL SETUP Tools General Safety Instructions General mechanic's tool set, SC 5180-90 WARNING Personnel Required High voltage is present on this equipment. Do not perform maintenance with power on. MOS 63J (3) Death or serious injury may result. Equipment Condition TM 10-3510-209-10, Extractor empty. SERVICE WARNING High voltage is present on this equipment. Do not perform maintenance with power on. Death or serious injury may result. NOTE Servicing of drive unit consists of checking oil level or adding oil to the turbine clutch. 1. Remove two screws (1) and flat washers (2) and remove inspection cover (3). 2. Rotate extractor basket (4) until oil level/fill plug (5) is visible. Remove plug. Oil level should be even with bottom of hole when extractor is on a level surface. CAUTION Too much or too little oil could damage equipment. 3. Refer to Direct Support Maintenance and LO 10-3510-209-12 for turbine oil instructions. 4. Replace oil level/fill plug (5). Install cover (3) and secure with two flat washers (2) and screws (1). 2-106 Change 1

Privacy Statement
Press Release
Contact