TM 10-3510-209-24
2-31.1. EXTRACTOR DRAIN PIPE ASSEMBLY
This task covers:
a. Inspection
c.
Disassembly
e.
Assembly
b. Removal
d.
Repair
f.
Installation
INITIAL SETUP
Tools
General Safety Instructions
General mechanic's tool set,
SC 5180-90
WARNING
High voltage is present on this equipment. Do not perform maintenance
Personnel Required
with power on. Death or serious injury may result.
MOS 63J (1)
Equipment Condition
Materials/Parts
TM 10-3510-209-10, Water pump removed.
Paragraph 2-22, Washer drivebelt cover removed.
TM 10-3510-209-10, Extractor drain hose disconnected.
TM 10-3510-209-10, Water drained from washer.
INSPECTION
1.
Inspect extractor drain pipe assembly for cracks, freeze breaks, corrosion, loose fittings and loose mountings.
2.
Remove inspection cap (1) on check valve (2). Remove any debris and obstructions from inside valve. Insure
interior gate swings freely.
REMOVAL
1.
Disconnect union joint (3) from extractor drain pipe assembly.
2.
Remove tie down straps from extractor drain pipe (7) as necessary.
3.
Remove extractor drain pipe by removing nut (5) that attaches bracket (4) to washer base.
DISASSEMBLY
1.
Remove coupling (6) and check valve (2) from extractor drain pipe (7).
2.
Remove two screws (8), and bracket (4) from extractor drain pipe (7).
REPAIR
WARNING
CARC produces toxic fumes when flame is applied. It is necessary to remove
CARC in area where flame is to be applied. Death can result.
1.
Solder or tighten fittings to stop leaks.
2.
Remove corrosion or foreign material from threaded joints.
3.
Replace broken or defective parts.
2-110 Change 1
