TM 55-1945-205-24-4
2-41. DRYER ASSEMBLY (CONT)
ADJUSTMENT (Cont)
3.
Adjust fuel pump pressure.
NOTE
Power must be applied to the dryer, and the dryer and fuel pump must be
operating, before the fuel pump pressure can be adjusted.
a.
Remove end cap (22) from adjusting
screw (23).
b.
Turn adjusting screw (23) until pressure
gauge (24) indicates approximately 100
psi (690 kPa).
c.
Install end cap (22) on adjusting screw
(23).
d.
Shut
down
dryer
(Refer
to
TM 10-3510-209-10).
4.
Adjust burner electrodes and nozzle.
WARNING
Allow burner area to cool before any maintenance actions are performed on the
burner assembly. Personal injury could result if burner is hot.
WARNING
Fuel is toxic and flammable. Close fuel shutoff valve before performing any
maintenance actions on the burner assembly.
a.
Close dryer fuel shutoff valve by turning handle in a clockwise direction.
2-145
