TM 10-3510-209-24
3-11. WASHER CONTROLLER ASSEMBLY
This task covers:
a. Test
c.
Adjustment
e.
Removal
b. Service
d.
Repair
f.
Installation
INITIAL SETUP
Tools
General Safety Instructions
Multimeter
General mechanic's tool set
WARNING
SC 5180-90
High voltage is present on this equipment.
Personnel Required
Do not perform maintenance with power on.
Death or serious injury may result.
MOS 63J (1)
Materials/Parts
Equipment Condition
Tiedown strap (Item 11, App C),
TM 10-3510-209-10, Tarp assembly removed.
Cleaning solvent (Item 10,
App C)
Wiping cloth (Item 3, App C)
TEST
NOTE
A standardized test has not been developed for the military design of the washer.
1.
Test operate all cycles and functions, both manual and automatic, of washer. Refer to TM 10-3510-209-10.
2.
Observe each function for proper and complete action.
3.
Check for incorrect timing or water temperature.
4.
Refer to malfunctions in troubleshooting section, (para 3-6) and perform corrective action.
WARNING
High voltage is present on this equipment. Do not perform maintenance with
power on. Death or serious injury may result.
5.
Use a multimeter and check each wire run from end to end. Check continuity of wound coils on each relay or
magnetic switch. Replace defective wires or coils. Refer to FIGURE 2-2.
3-31
