TM 10-3510-209-24
3-11. WASHER CONTROLLER ASSEMBLY (CONT)
ADJUSTMENT
Adjust controller contact fingers (1) by
laying a straightedge (2) along the
middle of fingers and bend the free ends
up or down to provide the proper tension
against drum (3).
REPAIR
WARNING
High voltage is present on this
equipment.
Do
not
perform
maintenance with power on, death or
serious injury may result.
1.
Inspect for cracks, breaks, dents, or other
damage.
WARNING
Welding procedures specified may
cause injury if safety precautions are
not
followed.
Wear
protective
clothing
and
eyewear
while
performing
welding
operations.
Serious injury could result.
2.
Weld minor cracks or breaks, straighten dents,
and replace missing or damaged hardware.
3.
Replace controller box (4) if damaged beyond
repair.
NOTE
A record of wire removal is needed
so that installation hookup is exactly
duplicated. Refer to FIGURE 2-2 for
wiring connections.
3-33