TM 10-3510-209-24
3-11. WASHER CONTROLLER ASSEMBLY (CONT)
REPAIR (Cont)
j.
Timer enable switch (19). Refer to FIGURE 2-2 and repair by replacement.
k.
Timer (9). Refer to FIGURE 2-2 and repair by replacement.
l.
Drum relays (20), (21), and (22). Refer to FIGURE 2-2 and repair by replacement.
m.
Drum and finger assembly (23). Refer to FIGURE 2-2 and repair by replacement.
5.
Drum motor replacement. Refer to FIGURE 2-2 and replace drum motor (24) as follows:
a.
Remove three screws (25) and cover (26).
b.
Disconnect two wires (27).
c.
Loosen setscrew (28) on shaft of motor (24).
d.
Remove four screws (29), four lockwashers (30), and motor (24).
e.
Replace unserviceable motor with new motor.
f.
Install new motor (24), four lockwashers (30), and four screws (29).
g.
Tighten setscrew (28) on shaft of motor (24).
h.
Connect two wires (27).
i.
Install cover (26) and three screws (25).
3-36
