TM 10-3510-209-24
3-11. WASHER CONTROLLER ASSEMBLY (CONT)
REMOVAL
WARNING
High voltage is present on this equipment. Do not perform maintenance with
power on. Death or serious injury may result.
1.
Remove six screws (31) and remove top panel (32) from controller (33).
NOTE
A record of wire removal is needed so that installation hookup is exactly
duplicated. See FIGURE 2-2.
2.
Locate wires coming from four conduits (34) on inside of controller (33). Tag and disconnect each wire
individually.
3.
Cut nylon wire ties as needed.
4.
Remove four locknuts (35) from conduit fittings on inside of controller (33). Remove conduit, fittings, and wires
from controller.
5.
Remove four locknuts (36), eight washers (37), and four screws (38) from controller (33) and stand (39).
6.
Remove controller (33) from stand (39).
INSTALLATION
WARNING
High voltage is present on this equipment. Do not perform maintenance with
power on. Death or serious injury may result.
1.
Position controller (33) on stand (39). Install four screws (38), eight washers (37), and four locknuts (36).
2.
Install wires and fittings of four conduits through holes of controller (33). Install four locknuts (35) on
conduit fittings.
3.
Connect each wire to its proper connector and remove tags. Tie wire bundles with wire ties (Item 11, App
C) as needed.
4.
Position top panel (32) on controller (33) and install six screws (31).
3-38
