TM 10-3510-209-24
3-14. POWER DISTRIBUTION PANEL (CONT)
INSTALLATION (CONT)
2.
Feed wires (11A) from connector (5A) through connector box (4A). Attach connector (5A) to connector box (4A)
using four screws (7A) and four lockwashers (6A).
3.
Insert rubber grommet (13A) into hole on side of panel box (5). Feed wires (11A) through gasket (3A) and rubber
grommet (13A) into panel box (5). Position connector box (4A) and gasket (3A) and secure from inside panel box with
four screws (1A) and four lockwashers (2A).
4.
Reconnect wires (11A) to panel box (5). Remove tags.
5.
Feed wires (10A) into panel box (5). Install conduit assembly (26) and conduit nut (25) on panel box.
6.
Reconnect wires (10A) to panel box (5). Remove tags.
7.
Feed wires (8A) into panel box (5). Install cable assembly (24) and nut (23) on panel box.
8.
Reconnect wires (8A) to panel box (5). Remove tags.
9.
Feed wires (9A) into panel box (5). Install cable assembly (22) and nut (21) on panel box (5).
10.
Reconnect wires (9A) to panel box (5). Remove tags.
11.
Install neutral wire (19) on connector block (18) and tighten large allen-head set screw. Remove tag.
12.
Install neutral wires (16) on connector strip (17) and tighten screws (15). Remove tags.
13.
Install six ground wires (13) on panel box (5) and secure with two screws (11) and lockwashers (12). Remove
tags.
3-52 Change 1
