TM 10-3510-209-24
3-28. DRYER TUMBLER DRIVE MOTOR AND GEARBOX
This task covers:
a. Removal
c. Repair
c. Installation
INITIAL SETUP
Tools
General Safety Instructions
General mechanic's tool set
SC 5180-90
WARNING
Personnel Required
High voltage is present on this equipment.
Do not perform maintenance with power on.
MOS 63J (2)
Death or serious injury may result.
Materials/Parts
Equipment Condition
Tumbler motor
TM 10-3510-209-10, Tarp assembly removed.
Tumbler gear box
REMOVAL
1.
Remove drive motor.
WARNING
High voltage is present on this equipment. Do not perform maintenance with
power on. Death or serious injury may result.
a.
Remove electrical power from the dryer.
b.
Remove four screws (1) and cover (2) from connector box (3).
NOTE
A record of wire removal is needed so that installation of wires on the replacement
motor is exactly duplicated. See FIGURE 2-4.
c.
Tag and disconnect electrical wires (4) from the terminals and connectors. Remove conduit nut (5) and
conduit (6) from connector box (3).
d.
Remove two bolts (7), flat washers (8), nuts (9), and coupling guard (10).
3-126
