TM 10-3510-220-24
2-41.
WATER HEATER FUEL FILTER ASSEMBLY (CONT)
REPAIR (Cont)
WARNING
Drycleaning solvent P-D-680 is toxic
and flammable. Wear protective gog-
gles and gloves and use only in a
well-ventilated area. Avoid contact
with skin, eyes, and clothes and don’t
breathe vapors. Do not use near open
flame or excessive heat. The flash
point is 100 - 138°F (38 - 59°C). If
you become dizzy while using clean-
ing solvent, get fresh air immediately
and get medical aid. If contact with
eyes is made, wash your eyes with
water and get medical aid imme-
diately.
4.
5.
6.
7.
Clean all parts in drycleaning solvent.
Install two preformed packings (14),
nipple (13), and handle (12) on fuel
filter (3).
Install gasket (20), filter bowl (19),
and securing plate (18) and secure to
fuel filter (3) with four screws (15).
Install brace (10) on fuel filter (3) and
secure with two screws (21),
lockwashers (17), and nuts (16).
INSTALLATION
1. Install large nipple (4) in filter (3)
inlet side and small nipple (2) in fuel
filter (3) outlet side.
2. Position fuel filter (3) on water heater
brace (8) and secure with two screws
(7), flat washers (6), lockwashers (8),
and nuts (9).
3. Connect hose (5) to large nipple (4).
4. Connect hose (1) to small nipple (2).
NOTE
If bowl and gasket were replaced,
ensure there are no fuel leaks.
5. Perform follow-on installation.
Install tarp assembly (TM 10-3510-
220-10).
2-145
