TM 10-3510-220-24
2-40. WATER MANIFOLD ASSEMBLY (CONT)
ASSEMBLY (Cont)
2. Install elbow (1), nipple (2), bushing (3) and coupling (4) onto nipple (36).
3. Install nipple (33) and tee (31) onto air actuated ball valve assembly (34).
4. Install nipple (30), bushing (27), street elbow (28) and coupling (29) onto tee (31).
5. Install nipple (32) onto tee (31) and place one clamp assembly (9) on nipple (32). Nuts (7)
tightened during installation.
6. Install air actuated ball valve assembly (16) onto nipple (32). Place another clamp assembly (9)
on nipple (6).
7. Install tee (14) to nipple (6).
8. Install reducer (13), hose fitting (12), gaskets (10) and connect hose (11).
9. Install nipple (18), bushing (17), elbow (19), hose barb (20), hose (22), coupling (23) and secure
with clamps (21).
INSTALLATION
NOTE
If manifold assembly has been disassembled or repaired the assembly
may required adjustment to mate with water heater attachment points.
Make adjustments by turning fittings or pipes as required.
1. Connect coupling (4) to fitting on top of water heater. Make alignment adjustments if
necessary.
2. Install two upper clamps (9). Install two lower clamps (9), six lock washers (8) and eight nuts
(7) onto clamp assemblies. When manifold is in desired position, tighten eight nuts (9).
3. Connect short water hose to water heater tee then connect opposite end to manifold assembly.
4. Connect washer water intake hose to manifold.
5. Connect the two air lines to elbows (5) as marked during removal.
2-141
