TM 10-3510-220-24
2-51.
DRYER BURNER ASSEMBLY (CONT)
REPAIR (Cont)
a.
b .
c.
d .
e.
f.
g.
h.
i.
j .
k.
l.
m.
n.
Disconnect electrical power from the dryer.
Remove the scanner (3) from the burner cover (4).
NOTE
The scanner is a sensitive device and should be handled with care.
Remove the six bolts (5) and lockwashers (6) from burner cover (4). Remove cover (4).
Remove two high voltage leads (7) by pulling out of transformer (1).
Remove six screws (10) and gasket (2) from the connector box cover (12) and remove cover.
Remove two conduit nuts (9).
Tag wires (13) and disconnect the leads to the transformer (1).
Remove two bolts (14) attaching transformer (1) to transformer brackets (15). Remove
transformer (1).
Install the new transformer (1) using two bolts (14) to the transformer brackets (15).
Connect wires (13) to their connections in the connector box (11) and remove tags.
Install conduit nuts (9) inside connector box (11).
Install gasket (2), cover (12) and six screws (10) to connector box (11).
Replace the two high voltage leads (7) to transformer (1).
Install burner cover (4) using six bolts (5) and lockwashers (6).
INSTALLATION
1.
2.
3.
4.
5.
Install plenum (4) into housing (1).
Install four bolts (23), lockwashers (3), and nuts (2).
Install new fuel nozzle (7) onto adapter (8).
Install two new electrodes (10) into base (5) and install nuts (6).
Tighten two setscrews (9) at the base of each electrode (10).
2-183
