TM 10-3510-220-24
3-10. WASHER ASSEMBLY (CONT)
ASSEMBLY (Cont)
3.
Install gear reducer unit and washer cylinder.
WARNING
Components of the washer assembly are
heavy and mav be awkward to handle.
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
lockwasher (39) and washer (40), do not
tighten bolt (38) at this time.
Slide washer cylinder basket shaft
through seal assembly and gear reducer
(36).
Seat drawband gaskets (33) in drawband
sections (32) and using socket head cap
screws (30) and nuts (31) loosely attach
drawband to lip at front of drum with
gasket in front of lip.
Place drum front (34) in lower section of
drawband (32) in front of gasket (33) and
using two screwdrivers snap under upper
section.
Evenly tighten drawband screws (30)
while tapping drawbands from top and
bottom center to sides with a plastic faced
mallet.
NOTE
Provide shims as necessary to provide
even tightening of drawband.
Adjust washer cylinder (35) position by
Use correct lifting procedures, lifting
devices, and/or assistance from other
personnel to avoid injury.
Position gear reducer (36) with mounting
plate in place on rear on washer unit and
align with seal assembly. Install bolt (38),
moving gear reducer (36) in slots on mounting
bracket.
Set clearance between drum front and washer
cylinder at 3/8” to 1/2” and tighten bolt (38).
Install key (41) in basket shaft (49) at gear
reducer (36).
Instal set collars (45) and (47) on both sides of
gear reducer (36) and tighten set screws (46)
and (48).
Install key (37), sheave and bushing assembly
(44) and secure with lockwashers (43) and
bolts (42).
3-26
