TM 10-3510-220-24
3-26. DRYER TUMBLER DRIVE MOTOR AND GEARBOX ASSEMBLY (CONT)
REMOVAL (Cont)
d.
Remove four bolts (11) lockwashers (10) and flatwashers (9) on the bottom of gear
reduction unit (13).
e.
Remove gear reduction unit (13) by removing chain sprocket (15) from drive chain (16).
f.
Loosen setscrew (17) from chain sprocket (15) and remove chain sprocket and sprocket key
(18) from shaft (14).
g.
Remove three capscrews (25), lockwashers (26) and cover (27) from trunnion (34).
h.
Remove lockwire, two capscrews (28), flatwashers (29) and keeper (30).
i.
Remove four capscrews (31), lockwashers (32), flat washers (33) and remove trunnion (34).
REPAIR
1. No repair is authorized on the tumbler motor. Replace the motor, if damaged or defective, with
a new motor.
2. No repair is authorized on the gear reduction unit. Replace unit if damaged or defective.
3-122
