TM 10-3510-220-24
Table 2-2. Unit Troubleshooting (Continued)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
37. WASHER DOES NOT FILL WITH COLD/HOT WATER (AUTOMATIC OR MANUAL
MODE). (Cont)
Step 3.
Check for stuck cold/hot water inlet valve. Activate with washer operating manual
program switches and observe valve operation.
a.
If inlet valve is defective, replace inlet valve. Refer to paragraph 2-22.
b .
If valve is serviceable and problem persists, notify your supervisor.
38. WASHER CYLINDER WILL NOT ROTATE (AUTOMATIC OR MANUAL MODE)
Step 1.
Check for blown fuse inside controller assembly.
a.
If fuse is blown, replace fuse.
b .
If fuse is serviceable, proceed to next step.
Step 2.
Check for loose or slipping drivebelt.
a.
If drivebelt is loose or slipping, adjust drivebelt for proper tension. Refer to
paragraph 2-23.
b.
If drivebelt is properly adjusted and problem persist, notify your supervisor.
39. WATER LEAKS AROUND WASHER DOOR.
Step 1.
Check for damaged door gasket.
a .
If door gasket is damaged and needs replacement, notify our supervisor.
b.
If door gasket is serviceable, proceed to next step.
Step 2.
Check for warped or damaged door.
a.
If door is damaged and needs replacement, notify our supervisor.
b.
If door is serviceable, proceed to next step.
Step 3.
Check for damaged glass or glass gasket.
If glass or glass gasket is defective and needs replacement, notify your supervisor.
2-42
