TM 10--3510--221--10 0024 00--7 LAUNDRY ADVANCED SYSTEM PREVENTIVE MAINTENANCE CHECKS AND SERVICES -- Continued 0024 00 TABLE 1. Operator PMCS -- Continued. ITEM NO. INTERVAL MAN-- HOUR ITEM TO BE CHECKED OR SERVICED PROCEDURE EQUIPMENT NOT READY/ AVAILABLE IF: 10 Before Still condenser Ensure fan guard (19) and inlet shroud (20) are not blocked with debris. Guard or shroud are blocked Ensure heat exchanger inlet screens (21) are not blocked with debris. Screens are blocked 11 Before Inverter enclosure Ensure inlet door (22) and outlet door (23) are not blocked with debris. Doors are closed or blocked 12 Before Still Ensure doors (24) are closed and knobs (25) are handtight. Doors are open and knobs are not tightened Ensure drain valves (26) are closed. Valves are open Ensure manual valve (27) is closed. Valve is open 13 Before Electrical supply Ensure external electrical power is available. If power is supplied by TQG ensure all PMCS has been done per TM 9--6115--644--10. External electrical power is not available Check main electrical cable (28) for damage and proper connection at external power source (29) and at LADS electrical box (30). Electrical cable is damaged or not connected 14 Before Anti--foam supply Check for adequate supply of anti--foam in external containers (31) and (32). Anti--foam supply is < 1 gal Shake anti--foam containers (31) and (32) to mix solution. Anti--foam has clumps. Ensure hand pump (33) is inserted completely into container(31). Hand pump is not fully inserted Ensure pickup tube (34) is properly connected at manual valve (27). Pickup tube is not properly connected Ensure pickup tube (35) is inserted completely into anti--foam container (32). Pickup tube is not fully inserted