TM 10--3510--221--100010 00--1LAUNDRY ADVANCED SYSTEM OPERATION UNDER USUAL CONDITIONSDAILY OPERATING PROCEDURES0010 00INITIAL SETUP:Maintenance Level Personnel RequiredOperator TwoDAILY OPERATING PROCEDURESA. System Start--upWARNINGOperating personnel must be familiar with system operation and emergencyprocedures prior to operating LADS. Failure to operate this system properly cancause severe injury or death to yourself or other personnel working nearby.If any hazardous or unusual conditions are observed during operation perform anemergency stop shutdown immediately (WP 0013 00).NOTEIf indications displayed at main control enclosure or at operator panels are not asstated in the following procedures refer to troubleshooting procedures (WP 0015 00)to determine the proper action to take.If the control system detects a system failure the audible alarm will go on and offintermittently. Further operations may or may not be interrupted, depending on howcritical the failure is. If this occurs the operator panel display will read:SYSTEM SHUTDOWNXXXXXX FAILUREorWASH CYCLE X IN PROGRESS PAUSEWASH= XXX F DRY= XXX FFILL FROM WASH TANKMODIFY TEMPSEXAMINE INPUTSXXXXXX FAILUREIn either case refer to troubleshooting procedures work package (WP 0015 00) todetermine the proper action to take.1. Ensure all BEFORE PMCS procedures have been completed (WP 0024 00).2. Bring MEP--805A generator on--line (TM 9--6115--644--10) or apply external power as required.3. Set generator output to 210 VAC, 60 HZ.4. Verify EMERGENCY STOP switch (WP 0008 00, Figure 1, 5 ) is pulled out.5. Position MAIN DISCONNECT switch (1) to ON.6. Position CONTROL POWER switch (3) to ON.7. Verify POWER lamps (WP 0008 00, Figure 2, 1) are on at operator panels A and B.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
