TM 10--3510--221--24
0031 00--2
DRYER INLET TEMPERATURE HI OR LO -- Continued
0031 00
NOTE
Pressure in air system must be maintained above 80 psig while performing the remaining
steps this procedure.
7. Use maintenance menu to open and close outlet damper (WP 0010 00). Observe damper operation.
Does outlet damper open and close?
YES Go to step 8.
NO Go to step 14.
8. Use maintenance menu to open and close outlet damper. Check damper opening and closing speed.
Does outlet damper open and close in 1 to 2 seconds?
YES Reinstall lint filter. Go to step 9.
NO Go to step 22.
9. Use maintenance menu to open and close inlet damper. Observe damper operation.
Does inlet damper open and close?
YES Go to step 10.
NO Go to step 14.
10. Use maintenance menu to open and close inlet damper. Check damper opening and closing speed.
Does inlet damper open and close in 10 to 20 seconds?
YES Go to step 11.
NO Go to step 22.
11. Use maintenance menu to turn on dryer blower. Observe blower operation.
Does blower come on?
YES Go to step 14.
NO Go to step DRYER BLOWER DOES NOT TURN ON FAULT (WP 0046 00).
12. Complete current laundry cycle the start another cycle (TM 10--3510--221--10).
13. During wash and rinse extracts verify that water is being drained and extracted from laundry.
Is water draining and extracting from drum?
YES Go to HEATING SYSTEM FAILURE (WP 0072 00).
NO Go to TYPICAL TANK NOT FILLING FAULT (WP 0037 00).
14. Check for obstruction that would prevent free movement of damper.
Are any obstructions found?
YES Repair as necessary.
NO Go to step 15.
15. Open door on main control enclosure. Verify SW1 and SW2 are ON.
