TM 10--3510--221--24
0234 00--3/4 blank
24 CHANNEL SSR PCB REPLACEMENT -- Continued
0234 00
INSTALLATION
1. Install three standoffs (14) onto new SSR PCB (2)
2. Insert two latch ejectors (15) into cable header (4).
3. Install SSRs (13) onto SSR PCB (2) as previously noted.
4. Install retaining bar (12), then secure with three thumb screws (11).
NOTE
Step 5 applies to PCB3 only and step 6 applies to PCB4 only.
5. Position SSR PCB3 (2) onto enclosure (8), then secure with eight screws (5), sealing washers (6), and nuts
(7).
6. Position SSR PCB4 (2) onto subpanel (9), then secure with eight screws (9) and lock washers (10).
7. Connect ribbon cable (3) to cable header (4).
8. Plug three wire headers (1) into SSR PCB (2).
9. Turn handle (16) CW, then close door (17).
10. Secure door (17) to main control enclosure (8) by tightening eleven latches (18).
11. Perform a test laundry cycle (TM 10--3510--221--10). Verify normal operation.
END OF WORK PACKAGE
