TM 10-3510-222-24
2-34. AIR COMPRESSOR.
This task covers:
a. Removal
b. Repair
c. Installation
d. Adjustment
INITIAL SETUP
Tools
General Mechanics Tool Kit (App B, Item 1)
Personnel Required
Two (for Adjustment)
Materials/Parts
Tags (App D, Item 4)
Equipment Condition
Laundry Unit shut down (TM 10-3510-222-10)
General Safety Instructions
WARNING
High
voltage
is
present
on
this
equipment.
Do
not
perform
maintenance with power on. Death or
serious injury may result.
a. REMOVAL
(1) On washer air tank (under rear of washer), open drain cock until pressure gage reads 0 psi.
(2) Close drain cock.
(3) Remove hose (1) from elbow (16).
(4) Loosen captive nut (2) on cover (3) and remove cover (3) from switch (4).
(5) Tag and disconnect electrical wiring to switch (4).
(6) Loosen screws (5) and rotate plate (6).
(7) Remove nut (7) from 90° adapter (8) and remove adapter (8).
(8) Remove four nuts (9), lockwashers (10), flat washers (11 and 12) and bolts (13) from bracket (15).
(9) Remove air compressor (14) from control stand (18).
b. REPAIR
(1) Handle (20).
(a) Remove two screws (19) and handle (20).
(b) Install new handle (20) with two screws (19).
(2) Fan (23).
(a) Remove two screws (21) and cover (22).
(b) Pull fan (23) from shaft (24).
(c) Push new fan (23) on shaft (24) 1/8 inch from end of shaft.
(d) Install cover (22) with two screws (21).
2-88
