TM 10-3510-222-24
3-22. WASHER - continued.
(13)
Remove air hoses (2 and 3) from washer control panel (37).
(14)
Disconnect three air hoses (19) from washer control panel (37).
(15)
Remove twelve screws (29) and washers (30), top cover (36) and washer control panel (37).
(16)
Tag and disconnect electrical wiring to conduit (33) and control panel (37) from Laundry Unit.
(17)
Remove connector nut (31), gasket (32) and flexible conduit (33) from washer control panel (37).
(18)
Disconnect air hoses (34 and 35) from washer control panel (37).
WARNING
Washer is heavy and awkward to handle. Serious injury could occur if moved without sufficient
personnel.
(19)
Remove four nuts (24), lockwashers (23), eight flat washers (22) and bolts (20) from washer control panel (37)
and washer control stand (21).
(20)
Support washer control panel (37) and remove washer (1) from Laundry Unit using suitable lifting device.
(21)
Position belt guard (15) on washer (1) and install four mounting studs (14).
b. REPAIR
NOTE
Washer repairs are covered in Paragraphs 3-23 thru 3-32.
c. INSTALLATION
(1)
Remove four mounting studs (14) from belt guard (15).
(2)
Remove belt guard (15) from washer (1).
(3)
Position washer (1) on Laundry Unit using suitable lifting device.
(4)
Install eight flat washers (22), four lockwashers (23) and nuts (24) on bolts (20) of washer control panel (37).
(5)
Install flat washer (27), lockwasher (26) and nut (25) on bolt (28) on washer (1) and Laundry Unit.
(6)
Install fifteen flat washers (9), lockwashers (10) and bolts (11) on washer (1) and Laundry Unit.
(7)
Connect air hoses (34 and 35) to washer control panel (37).
(8)
Install gasket (32), electrical connector and flexible conduit (33) and wiring in washer control panel (37). Secure
with nut (31).
NOTE
Wire numbers are stamped on each electrical wire. This information, in conjunction with data on
FO-2 Washer Wiring Diagram, may be used to connect wires if tags are lost or illegible.
(9)
Connect Laundry Unit electrical wiring to washer control panel (37).
3-34
