TM 10-3510-222-24
3-23. DOOR AND BAR - continued.
(i)
Install set screw (12) on block (9).
(j)
Position latch handle (6) on bar (11).
(k)
Install four screws (10) on block (9) and door and bar (11).
(l)
Install handle stop (8) and screw (7) on block (9).
(2)
Door (20).
(a)
Remove screw (21) and nut (22) from band (23).
(b)
Remove band (23) and gasket (24) from rim (25).
(c)
Remove four screws (26) from rim (25) and bar (11).
(d)
Remove eighteen nuts (27) and flat washers (28) from rim (25).
(e)
Remove retainer (29), gasket (30), window (31) and gasket (32) from rim (25). Discard gaskets (30 and
32).
(f)
Loosen set screw (33) and remove collar (34) from pin (35).
(g)
Remove pin (35), two bushings (36) and hinge (37).
(h)
Loosen set screw (33) and remove collar (38) from pin (35).
(i)
Install collar (38), tighten set screw (33) on pin (35).
(j)
Install pin (35), two bushings (36) and hinge (37) on bar (11).
(k)
Install collar (34), tighten set screw (33) on pin (35).
(l)
Position new gasket (32), window (31), new gasket (30) and retainer (29) on rim (25).
(m)
Install eighteen flat washers (28) and nuts (27) on rim (25).
(n)
Position rim (25) on bar (11) and install four screws (26).
(o)
Position gasket (24) on rim (25) and band (23). Install screw (21) and nut (22).
c. INSTALLATION
(1)
Apply plumbing fixture setting compound around the four mounting holes on washer where screws (1) will be
installed.
(2)
Position shim (5) and door and bar (4) on washer (3) and install four washers (2) and screws (1).
(3)
Close washer door (20).
3-39
