TM 10-3510-222-24
3-45. STARTER ENCLOSURE - continued
b. REPAIR
(1) Disassembly
(a) Remove four screws (13) and remove panel (29) from enclosure (30).
(b) Remove end bracket (14), divider (15), seven terminal blocks (16) and end bracket (17) from rail (25).
(c) Remove end bracket (20), circuit breaker (19), two end brackets (18), motor starter (21) and stop (22) from rail
(28).
(d) Remove two screws (23), lockwashers (24) and rail (25).
(e) Remove two screws (26), lockwashers (27) and rail (28).
(2) Assembly
(a) Position rail (28) on panel (29) and secure with two lockwashers (27) and screws (26).
(b) Position rail (25) on panel (29) and secure with lockwashers (24) and screws (23).
(c) Position circuit breaker (19) on rail (28) and install bracket (20) on end of rail (28) and two end brackets (18) to
the right of circuit breaker (19).
(d) Install motor starter (21) on rail (25) and secure with end bracket (22).
(e) Position end bracket (17), seven terminal blocks (16), divider (15) and end bracket (14) on rail (25).
(f) Position panel (29) in enclosure (30) and secure with four screws (13).
Figure 3-38. Extractor Starter Enclosure Repair
3-104
