TM 10-3510-222-24
3-45. STARTER ENCLOSURE - continued.
c.
INSTALLATION
(1)
Position enclosure (11) on extractor (12) and secure with four lockwashers (3), flat washers (4) and screws (2).
(2)
Install three gaskets (6) and box connector (7) on enclosure (11), secure with nuts (5).
NOTE
Wire numbers are stamped on each electrical wire. This information, in conjunction
with data on FO-3, Extractor Wiring Diagram, may be used to connect wires if tags
are lost or illegible.
(3)
Install plunger (9) on cover assembly (8) and secure with nut (10).
(4)
Position cover (8) on enclosure (11) and turn captive screws (1) 1/4 turn clockwise to lock cover in place.
Figure 3-39. Extractor Starter Enclosure Installation
3-105
