TM 10-3510-222-24
3-56. CONTROL PANEL.
This task covers: a. Removal
b. Repair
c. Installation
INITIAL SETUP
Tools
General Mechanics Tool Kit (App B, Item 1)
Automotive Vehicle Shop Equipment (App B,
Item 3)
Equipment Condition
Laundry Unit shut down (TM 10-3510-222-10)
Electrical Components removed (Para
3-51 thru 3-55)
Starter Box removed (Para 3-45)
General Safety Instructions
WARNING
Voltage in this equipment is high enough to cause
serious injury or death. Do not perform this task
with power on.
a.
REMOVAL
(1)
Remove locknut (1).
(2)
Remove elbow (2) from control panel (12) and remove gasket (3).
(3)
Support control panel (12) and remove four screws (4), lockwashers (5) and two clamps (6).
(4)
Remove control panel (12).
(5)
Remove three nuts (7), lockwashers (8) and flat washers (9).
(6)
Remove components board (10) and flat washers (11).
b.
REPAIR
WARNING
Chemical Agent Resistance Coating (CARC) produces
toxic fumes when flame is applied. It is necessary to
remove CARC in area where flame is to be applied.
Repair consists of welding of control panel (12). Refer to TM 9-257, Welding Theory Application.
c.
INSTALLATION
(1)
Position flat washers (11) and components board (10) on studs inside control panel (12) and secure with three
flat washers (9), lockwashers (8) and nuts (7).
(2)
Position control panel (12) on extractor (13) and install two clamps (6) with two lockwashers (5) and screws (4).
(3)
Install gasket (3) on elbow (2) and secure into control panel (12) with locknut (1).
(4)
Install electrical components (Para 3-51 thru 3-55).
(5)
Install starter box (Para 3-45).
3-130
