TM 10-3510-222-24
3-58. DRYER.
This task covers:
a.
Removal
b.
Repair
c.
Installation
INITIAL SETUP
Tools
General Mechanics Tool Kit (App B, Item 1)
Automotive Vehicle Shop Equipment (App B, Item 2)
Automotive Vehicle Shop Equipment (App B, Item 3)
Electrical Repair Shop Equipment (App B, Item 4)
Trailer Mounted Welding Shop (App B, Item 8)
Suitable Lifting Device
Material/Parts
Strap, Tiedown (App D, Item 11)
Tags (App D, Item 4)
Personnel Required
Four
Equipment Condition
Laundry Unit shut down (TM 10-3510-222-10)
Fuel Input Hoses disconnected (TM 10-3510-222-10)
Air Hoses disconnected (TM 10-3510-222-10)
Cover (ON/OFF Switch) open (Para 3-63)
Rear Frame removed (Para 2-19)
General Safety Instructions
WARNING
Dryer weighs 1060 lbs and requires a
lifting device for removal and installation.
Attempt to remove or install without it
may result in injury and/or damage to the
equipment.
a.
REMOVAL
(1)
Remove eleven nuts (1), sixteen lockwashers (2), flat washers (3) and screws (4 and 5).
(2)
Loosen three screws (6), tag and disconnect wires (7) (wire numbers 29, 30 and 31) from starter switch (8),
and disconnect (green) ground wires (wire numbers 32 and 33) from terminal board.
(3)
Remove tiedown straps (9) as required and unscrew nut (10) from elbow (12).
(4)
Pull elbow (12) and wires (7) away from dryer base (13) and remove gasket (11).
(5)
Remove dryer using a suitable lifting device from Laundry Unit.
b.
REPAIR
NOTE
Dryer repairs are covered in Paragraphs 3-59 thru 3-84.
c.
INSTALLATION
(1)
Position dryer using a suitable lifting device on Laundry Unit.
NOTE
If screw goes into threaded hole, install lockwashers and flat washers on top.
(2)
Install eleven screws (4), flat washers (3), lockwashers (2) and nuts (1) in unthreaded holes.
(3)
Install five screws (5), flat washers (3) and lockwashers (2) in threaded holes.
(4)
Position gasket (11) on elbow (12) and feed wires (7) into dryer base (13).
(5)
Secure elbow (12) with nut (10).
3-136
