TM 10-3510-223-13&P 0016 00
0016 00-2
WARNING
This equipment operates at High Voltages. Use extreme caution. Turn
Main Breakers in Circuit Breaker Box #1 and #2 OFF, before proceeding
with this procedure. Touching a live wire can cause serious injury or
death.
REPLACE
Replace damaged or otherwise unserviceable switches and receptacles by removing the applicable
section of the raceway using a flathead screwdriver. Then proceed as follows:
To remove the light switch (1) located in the roadside raceway, remove the cover (2) and switch
installation screws (3). Remove mounting frame (4) from raceway (5). Retain the installation clips (6).
Loosen and remove the wires from switch (7), noting the method of attachment.
To install a new switch (1), place the installation clips (6) onto the frame (4) and secure the switch onto
the frame and clips with the installation screws (3). Attach the wires (7) onto the new switch (1) in the
same manner as removed. Clip frame with switch installed onto the raceway. Replace cover (2).
5
2
1
3
7
4
6
6
