TM 10-3510-223-13&P
0041 00
CONTAINERIZED SELF SERVICE LAUNDRY (CSSL) MODEL A
DIRECT SUPPORT MAINTENANCE
0041 00-1
WASHER/DRYER
THIS SECTION COVERS:
Repair, Replace
INITIAL SETUP
CSSL not in operation
Materials/Parts
Maintenance Level
Wiping Rags (WP 0072, Table 1, Item 1)
Direct Support
Vbelt, Pump, (WP 0072, Table 1, Item 20)
Tools and Special Tools
Vbelt, Drive, (WP 0072, Table 1, Item 21)
Tool Kit, Org. Maintenance Common No.1
(WP 0045, Table 2, Item 2)
WARNING
This equipment operates at High Voltages. Use extreme caution.
Observe all warnings, and follow all safety procedures. Touching a live
wire can cause serious injury or death. The procedures in this work
package can be performed only by qualified civilian or military personnel
in MOS 51R, 52C, 52D, or 52G.
REPAIR
Before repairing a washer/dryer, set the main breakers in power distribution panel #1 and #2 (Refer to
work package 0004) to OFF. Place shipping basket in washer prior to beginning procedure. Repair a
washer/dryer by replacing the power cord as described in work package 0074, Figure 5, or the water
pump and drive belt as described herein. The washer/dryer must be removed as described below, to
make these repairs.
Water Pump Belt Replacement. To replace the washer water pump belt, proceed as follows:
Check for proper belt adjustment. When grasping .
the installed belt in the middle, there should be ¼” clearance between
the inside surfaces of the belt. Adjust belt by repositioning the pump as
necessary.
Remove the washer to be repaired as described under REMOVE and
REPLACE below.
Lay the washer on its’ front for access. Remove broken pump belt.
Loosen three screws (1) from the bottom of the base holding the
pump in place. This will provide enough slack to install a new belt.
Place new belt over motor (2) and pump (3) pulleys. Place pump in
original position and secure base screws.
2
3
1
