TM 10-3510-223-13&P
0041 00
0041 00-4
Install
WARNING
The washer/dryer and stand are heavy. To avoid injuries, two persons
are required to lift and handle the washer/dryer and stand.
NOTE
Prior to installation of a new washer, or frame-mounted washer/dryer,
modify the washer as described in work package 0074, Figure 5.
Disconnect the 15-pin plastic electrical cord plug (1) at the rear of the new washer/dryer unit. Remove the
front (2) of the new washer (3) by removing two retainer screws (4). Using a cross-tipped screwdriver,
remove two bolts (5) from the rear of the stand (6). Remove the new washer from the stand.
Place retained spacers (7) into position on floor mount and align holes. Place stand (6) and dryer onto
floor mount (8) and spacer (7). Install three bolts (9) on each side of the stand (6) through the spacer into
the floor mount.
Slide washer into position on stand (6) and, using a cross-tipped screwdriver install two bolts (5) through
rear of frame. Reinstall washer front (2) using retained screws (4).
Install top frame (10) onto container wall using the retained hex nuts and flat washers (11). Install retained
hex screws and flat washers (12) securing top of dryer units to top frame (10).
WARNING
Use caution when installing sheet metal elbow duct. Sharp metal edges
may cause injuries such as cuts and bruises.
Install retained sheet metal elbow duct (13) onto dryer duct outlet. Install fresh water hoses (14),
wastewater hose (15), and exhaust ducts (16).
Connect 15-pin plastic electrical cord plug and socket connectors (1) on the back of the washer/dryer.
Plug power cord (17) into the ceiling raceway (18).
Open washer and remove shipping bracket (19). Place the bracket on top of dryer. Open dryer and
remove any items placed there for shipment.
Set main breakers in power distribution panel #1 and # 2 to ON.
