TM 10-3510-224-13&P 0032 00
Ballast.
1. Disconnect the wire nuts (11) and tag the wires (12) from the ballast (13).
2. Remove hardware (14) securing the ballast (13) to the fixture.
3. Remove the ballast (13).
4. Secure the new ballast to the fixture using the retained hardware (14).
5. Connect the ballast wires (12) with wire nuts (11) and tape the wire nuts with electrical tape.
6. Install the reflector (8) using the reflector retainers (7).
7. Install the fluorescent light bulbs (6) and the insulators (4).
8. Position the dust cover (1) on the fixture and secure it with the retainer clips (3).
9. Place Circuit Breaker #1 on Circuit Breaker Panel #1 to ON position.
10
9
11
8
5
7
14
3
2
12
13
6
11
4
1
END OF WORK PACKAGE
0032 00-2
