TM 10-3510-224-13&P
0006 00
0006 00-2
Using a 3,000 Gallon Freshwater Tank:
1. Shut off the freshwater pump (1) by setting circuit breaker # 3 in the right side Power Distribution Panel
to OFF. Disconnect the 2” freshwater hose (2) from the freshwater inlet panel (3) on the utility wall. While
holding the end of the hose above the water level in the freshwater tank (4), place the end of the hose (2)
into the freshwater tank as shown.
2. Connect garden hose to the hose fitting (6) located at the end of the supply line (behind washer/dryer
#6) and open (handle in line with water line) the ball valve (7). Leave the valve open after system has
drained. Disconnect garden hose, drain and coil it, connect the ends together and set it aside.
3. Drain the 3,000 Gallon freshwater tank (4) in accordance with TM 10-5430-237-12&P. Remove the 2”
freshwater hose (2) from the freshwater tank. Drain the hose, coil it, connect the ends together and set it
aside.
4. Place the garden hose inside the CSSL. Coil and place the 2” freshwater hose (2) together with the
3,000 Gallon freshwater tank (4) inside the CSSL.
WARNING
Avoid spillage of wastewater. Drain wastewater hoses into an approved
disposal facility. Keep wastewater hoses away from freshwater hoses
and any freshwater supply in the vicinity. Serious health problems may
result from freshwater contamination.
5. After the sump pump (8) has stopped running, shut off the pump (Circuit Breaker #12, right side Power
Distribution Panel).
Using a Municipal Disposal System:
1. Disconnect the 2” wastewater hose (9) from the wastewater panel (10) on the utility wall, and drain it
into the disposal connection.
2. Disconnect the 2” wastewater hose (9) from the wastewater disposal point. Coil the hose and set it
aside. Install the dust cap (11) on the panel (10).
Using a 3,000 Gallon Wastewater Collection Tank:
1. Disconnect the 2” wastewater hose (9) from the wastewater panel (10) on the utility wall. While holding
the end of the hose above the water level in the 3,000 Gallon wastewater tank (12), place the end of the
hose into the wastewater tank as shown. Install dust cap (11) on panel (10).
2. Empty the 3,000 Gallon wastewater tank (12) in accordance with TM 10-5430-237-12&P. Remove the
2” wastewater hose (9) from the wastewater tank. Drain the hose, coil it, and set aside.
3. Place the 2” wastewater hose (9) and the 3,000 Gallon wastewater tank (12) inside the CSSL.
