TM 10-3510-226-23
0043 00
REPLACE
Replace the Washer Reuse Tank Dump Valve
WARNING
Ensure that the washer electrical power is shut off and disconnected before proceeding.
The circuit breaker box should be locked by personnel following this procedure. Serious
injury or death can result from electrocution if proper safety precautions are not observed.
WARNING
The washer is extremely heavy. Use caution when lifting and blocking the washer, and
do not allow unnecessary personnel in the immediate area while it is being moved.
Serious injury or death may result if safety precautions are not observed.
CAUTION
The washer is a large, heavy piece of machinery being moved out of a confined space.
Before removal and installation, remove or protect any equipment which might be
damaged by the washer on its way in or out.
1. Remove washer IAW procedures given in WP 0041 00.
2. Tag and disconnect wiring from dump valve (Figure 2, Item 1).
3. Tag and disconnect hoses from dump valve (Figure 2, Item 1).
4. Remove screws, nuts, and washers retaining dump valve (Figure 2, Item 1) to mounting bracket
(Figure 2, Item 2), and remove dump valve.
5. Install replacement dump valve (Figure 2, Item 1), and retain with screws, washers, and nuts.
6. Connect hoses to dump valve (Figure 2, Item 1) as tagged.
CAUTION
Ensure the wire connections are placed on the 60 Hz terminals as marked on the valve
motor. Connection to the 50 Hz terminals will impair performance and reduce the
operating life of the valve motor.
7. Reconnect wiring to dump valve (Figure 2, Item 1) as tagged.
8. Install washer IAW procedures given in WP 0041 00.
0043 00-3
