TM 10-3510-226-23
UNIT MAINTENANCE
CONTAINERIZED BATCH LAUNDRY
NSN 3510-01-527-2209
NSN 3510-01-527-2210
VALVE, REUSE PUMP DUMP
TEST, REPLACE
INITIAL SETUP
Tools
Personnel Required
Tool Kit, General Mechanics: Automotive (WP
Quartermaster and Chemical Equipment Repairer 63J
(2)
Materials/Parts
Equipment Condition
Wire Markers (WP 0087 00, Item 58)
CBL set up
References
TEST
Test the Washer Reuse Tank Dump Valve
WARNING
Ensure that the washer electrical power is shut off and disconnected before proceeding.
The circuit breaker box should be locked by personnel following this procedure. Serious
injury or death can result from electrocution if proper safety precautions are not observed.
WARNING
The washer is extremely heavy. Use caution when lifting and blocking the washer, and
do not allow unnecessary personnel in the immediate area while it is being moved.
Serious injury or death may result if safety precautions are not observed.
CAUTION
The washer is a large, heavy piece of machinery being moved out of a confined space.
Before removal and installation, remove or protect any equipment that might be damaged
by the washer on its way in or out.
1. Remove washer IAW procedures given in WP 0041 00.
2. Tag and disconnect wiring from dump valve (Figure 1, Item 1).
3. Use an ohmmeter to test for 110 to 120 ohms resistance.
4. Replace a dump valve with an open solenoid (Figure 1, Item 1).
5. Reconnect wiring as tagged.
6. Install washer IAW procedures given in WP 0041 00.
