TM 10-3530-207-14
Table 2-1. Operator Preventive Maintenance Checks and Services for Clothing Repair Shop.
ITEM
INTERVAL
LOCATION
PROCEDURE
NOT FULLY MISSION
NO.
ITEM TO CHECK/
CAPABLE IF:
SERVICE
GROMMET
PRESS-
continued
36
Weekly
Plunger
Inspect plunger for burred, nicked,
Burred, nicked or
or corroded surfaces; for mechanical
binding
binding, and for loose mounting.
Replace the grommet press if any of
the above conditions exist (para. 2-18).
37
Weekly
Upper and lower
Inspect the chucks and dies for
Burred or nicked
dies
dirty, nicked, burred, or corroded
surfaces and for loose mounting.
Make certain the chucks and dies
will fit into position without
mechanical binding. Clean a dirty
die (para. 4-64). Replace any
defective die.
38
Weekly
Frame
Inspect for cracked or broken frame.
Cracked or broken
Inspect for dirty surfaces, for loose
or missing nuts and screws, and for
loose mounting to the table. Clean
a dirty grommet press. Tighten
loose mounting nuts (para. 2-8).
Replace the grommet press if any of
the other above conditions exist.
39
Weekly
Plunger return
Inspect the plunger return spring
Bent or broken
spring for bent or broken coils and for loose
mounting. Replace the grommet
press if any of the above conditions
exist (para. 2-18).
4-23
