TM 10-4510-201-14
Section VI. MAINTENANCE OF SHOWER STAND AND WATER PUMP
positioned properly and the nozzle body threads are not
3-9. General
crossed on the adapter. Tighten the nozzle body
This section describes maintenance functions of items
securely.
which are listed in Group No. 02 of the MAC and which
the operator must perform. Any deficiency which the
(2) Clean the nozzle body (4, fig. 3-5) on
operator is not authorized to correct must be reported as
Army models SPE 41, SPE 44, York-Shipley Model
stipulated by TM 38750.
YS49279, and Army Model SPE 45 as follows:
(a) Unscrew and remove the body from
the adapter (1). Remove the gasket (2) and the washer
(3) from the body.
mountings.
(b) Clean all dirt and grit from the
nozzle body.
b. Cleaning.
(c) Reverse the procedure in (a) above
(1) Clean the nozzle body (3, fig. 3-4) and the
to assemble the nozzle, making certain the nozzle: body
insert (2) used on Army models SPE 35 and SPE 35A,
threads are not crossed on the adapter. Hand tighten
as follows:
the nozzle body securely.
(a) Unscrew and remove the body from
c. Removal. Unscrew and remove the complete
the adapter (1), and remove the insert from the body.
nozzle (on any model) from the shower head and
(b) Clean all dirt and grit from the
replace defective nozzle as authorized.
nozzle body and from the insert.
d. Installation. Reverse the procedure in c above.
(c) Reverse the procedure in (a) above
to assemble the nozzle, making certain the insert is
