TM 10-4510-207-14
NOTE
The following procedure applies to both panels. The quantities listed are
for one panel only.
(c) Left/Right Side Panels. Place two pieces of lumber (11) (Appendix F, Figure F-6, Item 3) and three equally
spaced pieces of lumber (12) (Appendix F, Figure F-6, Item 1) onto one sheet of plywood (13) (Appendix F,
Figure F-7, Item 2) as illustrated. Secure the lumber to plywood to using construction staples, nails, or glue
as available.
(d.) Assemble the front, back, left, and right side panels onto the bottom panel as illustrated. Secure the panels
to bottom and each other using construction staples, nails, or glue as available.
NOTE
The following procedures apply to multiple items. The quantities listed
in the procedures are for only one item.
(3) Position folding handle (14) in place as illustrated and mark mounting hole locations. Drill 10 mounting holes
necessary and insert 10 tee nuts (15) form inside box. Position folding handle in place and align mounting holes
then secure 10 screws (16). Repeat procedure for remaining five folding handles
(4) Position bail handle (17) in place as illustrated and mark mounting hole locations. Drill five mounting holes a
necessary and insert five tee nuts (18) form inside box. Position bail handle in place and align mounting holes
then secure using five screws (19). Repeat procedure for remaining three bail handles.
(5) Place lid on box and position hinge (20) in place as illustrated. Mark mounting hole locations and drill eight
pilot holes (four in lid and four in box). Position hinge in place and align mounting holes then secure using
eight screws (21) (four in lid and four in box). Repeat procedure for remaining three hinges.
(6) Position latch (22) in place as illustrated. Mark mounting holes locations and drill six pilot holes (three in lid
and three in box). Position latch in place and align mounting holed then secure using six screws (23) (three in
lid and three in box). Repeat procedure for remaining two latches.
5-15/(5-16 blank)
