TM 10-4510-207-14
5.5. STORAGE CONTAINER REPLACEMENT.
This task covers: a. Disassembly b. Assembly
INITIAL SETUP
General Safety Instructions:
Tools:
General Mechanics Tool Set (Appendix B, Section III,
Storage container empty.
Item 1).
Drill (Appendix B, Section III, Item 3)
Drill Set (Appendix B Section III, Item 3)
NOTE
Salvaging usable hardware items from the old storage container is the
only disassembly applicable to replacing the container.
a. Disassembly. Remove any usable hardware items from the old storage container. See paragraph 4.18.
Replace any un-usable or missing hardware items to make a complete set for assembly.
NOTE
Replacement of the storage container consist of assembling a new
container using salvaged or new hardware and bulk lumber and
plywood.
b. Assembly.
(1) Fabricate Lid. Place two pieces of lumber (1) (Appendix F, Figure F-6 Item 4) and four equally spaced
pieces of lumber (2) (Appendix F, Figure F-6 Item 5) onto one sheet of plywood (3) (Appendix f, Figure
F-7, Item 4) as illustrated. Secure the lumber to plywood using construction staples, nails, or glue as
available.
(2) Fabricate Box.
(a) Bottom Panel. Place two pieces of lumber (4) Appendix F, figure F-6, Item 4) and four equally
spaced pieces of lumber (5) (Appendix F, Figure F-6, Item 5) onto sheet of plywood (6) (Appendix F,
centerpieces of lumber (5) as illustrated. Secure the lumber to plywood using construction staples, nails,
or glue as available. Turn bottom over so it is supported by the two pieces of lumber (7) as illustrated.
NOTE
The following procedure applies to both panels. The quantities listed
are for one panel only.
(b) Front/Back Panels. Place two pieces of lumber (8) (Appendix F, figure F-6, Item 4) and four equally
spaced pieces of lumber (9) (Appendix F, Figure F-6, Item 1) onto one sheet of plywood (10)
staples, nails, or glue as available.
5-13
